Driver, Lathe Dog, Individual Sizes
Driver, Lathe Dog, Individual Sizes
In stock
SKU:4476Shelf Location: (D02 - 08)
Couldn't load pickup availability
Key Features
Key Features
- Lathe Dog Driving Pin
- For mini lathes
- M6 Lathe dog drivers into 80 mm (3") chuck mounting flanges
- M8 Lathe dog drivers into 100 mm (4") chuck mounting flanges
Share
WARNING: This product can expose you to chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
View full details

Product Information
Description
Lathe dog drivers act as a holding pin when using a lathe dog that has a straight tail. Bolt the M6 Lathe dog drivers into 80 mm (3") faceplates that have M6 mounting holes. Bolt the M8 Lathe dog drivers into 100 mm (4") faceplates that have M8 mounting holes.
Chris' Tips
The photo shows how to use a lathe dog and drive pin with the mini lathe.

Lathe dogs are the perfect solution for turning between centers. (That's where you mount a dead center in the headstock and another center -- usually a live center -- in the tailstock. (see our live and dead centers here!)You then mount the workpiece, which has a small divot machined into each end, between the centers.
To drive the workpiece, you place a lathe dog on it; the lathe dog is pushed around by a driver pin screwed in to a faceplate or the spindle.
Sounds complicated, right? So why turn between centers instead of just chucking your workpiece?
- It's very concentric, accurate (less runout than a chuck), and repeatable. That means you can remove your workpiece, measure it, test it, even flip it end for end -- and then put it right back on center.
- Because of this accuracy, it's easier to blend cuts that you make from both ends.
- It's easier for long or irregular workpieces that don't easily fit in a chuck.
- By offsetting the tailstock, you can accurately turn tapers.