Menu

Mini Mill Tooling

1 Introduction
2 Tool Holding
3 Drill Chucks
4 Holding End Mills
5 Drawbars
6 End Mills
7 Work Holding
8 Vises
9 Clamping Kits and Accessories
10 Setup Tools
11 Special Operations
12 Surfacing
13 Boring
14 Cutting Curves
15 Indexing
16 Tooling Packages
17 Spare Parts Kits
Mini Mill Tooling

Clamping Kits and Accessories

Clamping kits and their accessories, including 1-2-3 blocks, are the "Erector Sets" of work holding. Use the various pieces of the clamping kit as you see fit to hold work pieces to the mini mill's table.

Clamping kit

In many cases, you need to lift the work piece off the table, either because the mill spindle won't reach it or because of a projection on the bottom of the work piece. 1-2-3 blocks are precision ground to be flat and parallel. Use them as spacers to lift the work piece. You can also use them as an angle plate by bolting a work piece to the side of the 1-2-3 block and then clamping the 1-2-3 block to the mill table.

Clamping Kit and Accessory Options

Part
Number
Product

1144

Clamping Kit, 7/16" T-Slot

5975

Clamping Kit, 7/16" T-Slot, Professional Grade

1233

Blocks, 1-2-3

 

Printer Friendly Version < Previous   Next >