Mini Mill Tooling

1 Introduction
2 Tool Holding
3 Drill Chucks
4 Holding End Mills
5 Drawbars
6 End Mills
7 Work Holding
8 Vises
9 Clamping Kits and Accessories
10 Setup Tools
11 Special Operations
12 Surfacing
13 Boring
14 Cutting Curves
15 Indexing
16 Tooling Packages
17 Spare Parts Kits
Mini Mill Tooling

Work Holding

There are two main ways to hold work on a mill's table: with a vise or by clamping the work piece to the table. In our experience, most work can be held in a vise. But from time to time there is a large or odd-shaped work piece that must be clamped to the table.


Printer Friendly Version < Previous   Next >